![]() I tried a soft reset on the BMS by charging the battery for a only a minute via the discharge port, but no luck there, it still doesn't charge.There was 54 volts at the discharge port with the charger plugged in. When I plugged this charger in, the light stayed green on the charger instead of changing to amber and the fan turning on as it normally does when it's charging a battery. I tried a known working charger with the same specifications and plug type. ![]() The charger has a green light before plugging it into the battery, it blinks red when plugged into the battery, and there is zero voltage at the discharge port with the charger left plugged in. I attempted to test the output voltage of factory charger, but I think this charger is one that doesn't put out any voltage until there is a load.With battery off the bike and no charger, there is zero voltage at the charge and discharge ports, and obviously no lights at charge level indicator on the battery.The symptom the dreaded blinking red light on the charger, so I knew right away that aside from anything else that might be wrong, there's either a battery or charger problem. I have been down this road before, and thanks to all the amazing advice, tips and tricks I have received on this forum in the past, I at least knew where to start with troubleshooting. I picked up a used, non-operational iZip E3 Dash, the price and the challenge to get it back on the road were too great to resist :wink:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |